It was bound to happen.

One of the boards I designed simply does not work. Worse, it’s not a simple error: I can’t simply cut one or two lines on the board and run jumpers. Turns out a bunch of resistors were incorrectly wired to power–and cutting them would require so much work it’s easier to basically start over again.

And it was such a rookie mistake, too.

That means my hope for having the accumulator and flags registers connected to the ALU will have to wait a few weeks. Meanwhile I suppose I can start building the B through E registers…

Leave a Reply

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

Blog at WordPress.com.

Up ↑

%d bloggers like this: